Message Boards

Guidelines

  • Please be sure posts are category appropriate.
  • No off-topic or off-color postings.
  • Postings may be deleted at the discretion of HGTV Moderators.
  • No advertising is allowed.
  • Be Nice. No name calling, personal attacks or flaming.
  • Certain words will trigger moderation of the post. These words mostly cover political and religious topics, which are OFF the topics covered by HGTV.
  • For general message board help, click the tab labeled "Tools," and choose "Help" from the dropdown menu.
Full Guidelines

  HGTV.com
  HGTV Message Boards
Hop To Forum Categories   Remodeling
Hop To Forums   General Remodeling
  how can I remove a false drawer to replace the hinges?
Go
New
Find
Notify
Tools
Reply
  
how can I remove a false drawer to replace the hinges? Sign In/Join 
posted
It looks like it's glued on.
 
Posts: 2006 | Location: Arkansas Zone 7 | Registered: Aug 18, 2005Reply With QuoteReport This Post
posted Hide Post
Little confused. Drawers don't have hinges.
 
Posts: 686 | Location: Applachain | Registered: Feb 13, 2007Reply With QuoteReport This Post
posted Hide Post
It's in front of the sink and made to look like a drawer but actually the door pulls down rather than out.
 
Posts: 2006 | Location: Arkansas Zone 7 | Registered: Aug 18, 2005Reply With QuoteReport This Post
Picture of conrad
posted Hide Post
Sometimes the false drawer panels are screwed in from the inside or have little clips in the corners. And then some may be glued. Use a mirror and flashlight to peek up there from the inside?

I would try tapping it out. Small hammer sideways and from the inside. If you can get it to move on one side, you can better see how it is attached.
 
Posts: 8530 | Location: Plains & Mountains | Registered: Jun 08, 2003Reply With QuoteReport This Post
Picture of Sparky
posted Hide Post
They are usually held on by clips, not glue. Can you see between the sink and the backside of the drawer front?


General Disclaimer

Any advice given here is general in nature and is not necessarily valid for your given area. If in doubt check with your local codes enforcement department for what is required when doing electrical, plumbing or structural work on your house. Permits may or may not be required in your area and home owners may not be able to DIY some tasks. I have no way of knowing if you have the skills needed to complete the tasks you are asking about, when in doubt seek professional assistance.

My advice may be worth exactly what you pay me for it. :-) For the record I did not stay in a Holiday Inn Express last night.

 
Posts: 6657 | Location: Cary, North Carolina | Registered: Sep 18, 2002Reply With QuoteReport This Post
posted Hide Post
If it pulls down to open for a couple compartments, then pull it down to see what is there. If I recall correctly the plastic compartments lift out and you will see a special kind of hinge that is fastened to the sides of the opening.

Question: If you remove it, what will you put in its place?
 
Posts: 12114 | Location: Eagle, CO USA | Registered: Sep 18, 2002Reply With QuoteReport This Post
posted Hide Post
I looked under there and didn't see anything. I could see light on one side and most of the top which led me to believe the left side was glued. I don't want to remove it, I want to change the hinge and I can't do that unless I can get it open.
The one in front of the other sink opens. Don't know why they didn't leave this one open.

This message has been edited. Last edited by: Sis2,
 
Posts: 2006 | Location: Arkansas Zone 7 | Registered: Aug 18, 2005Reply With QuoteReport This Post
posted Hide Post
I'm not understanding what you are seeing, and I have installed a number of these drop-down doors. Is the hinge pin visible from the front on your doors?
 
Posts: 12114 | Location: Eagle, CO USA | Registered: Sep 18, 2002Reply With QuoteReport This Post
posted Hide Post
yes
 
Posts: 2006 | Location: Arkansas Zone 7 | Registered: Aug 18, 2005Reply With QuoteReport This Post
posted Hide Post
Ok, then you have somewhat standard hinges on the drop-down drawer fronts. There has to be a way to get at the screws holding the hinges in place; after all, the person installing them was no magician! Are there removable plastic (or metal) liners in those drop-down drawers? If so, they will probably be just set in place.

I would also expect that you will need a stubby screwdriver to remove the hinges. Sorry, if this is sounding complicated. Is it possible for you to include a photo or two?
 
Posts: 12114 | Location: Eagle, CO USA | Registered: Sep 18, 2002Reply With QuoteReport This Post
posted Hide Post
No they don't have liners in them and yes I can get to the screws with great difficulty but I still won't be able to get the hinges out without being able to open the stupid thing. I've finally decided it's painted shut in just one corner so I called the guy that's going to paint the bathroom and asked him if he could get it loose. Sounds like he can.

Thanks for your help
 
Posts: 2006 | Location: Arkansas Zone 7 | Registered: Aug 18, 2005Reply With QuoteReport This Post
posted Hide Post
In my experience screws in hinges placed like that will need either a stubby screwdriver or a small ratcheting offset driver, neither of which you may have.

Hope the painter can take care of it for you.
 
Posts: 12114 | Location: Eagle, CO USA | Registered: Sep 18, 2002Reply With QuoteReport This Post
  Powered by Social Strata  
 

HGTV.com    HGTV Message Boards  Hop To Forum Categories  Remodeling  Hop To Forums  General Remodeling    how can I remove a false drawer to replace the hinges?