how can I remove a false drawer to replace the hinges?
It looks like it's glued on.
Sep 16, 2012, 08:20 AM
redoverfarm
Little confused. Drawers don't have hinges.
Sep 16, 2012, 01:23 PM
Sis2
It's in front of the sink and made to look like a drawer but actually the door pulls down rather than out.
Sep 16, 2012, 01:52 PM
conrad
Sometimes the false drawer panels are screwed in from the inside or have little clips in the corners. And then some may be glued. Use a mirror and flashlight to peek up there from the inside?
I would try tapping it out. Small hammer sideways and from the inside. If you can get it to move on one side, you can better see how it is attached.
Sep 16, 2012, 01:52 PM
Sparky
They are usually held on by clips, not glue. Can you see between the sink and the backside of the drawer front?
General Disclaimer
Any advice given here is general in nature and is not necessarily valid for your given area. If in doubt check with your local codes enforcement department for what is required when doing electrical, plumbing or structural work on your house. Permits may or may not be required in your area and home owners may not be able to DIY some tasks. I have no way of knowing if you have the skills needed to complete the tasks you are asking about, when in doubt seek professional assistance.
My advice may be worth exactly what you pay me for it. :-) For the record I did not stay in a Holiday Inn Express last night.
Sep 16, 2012, 03:38 PM
Bob Fleming
If it pulls down to open for a couple compartments, then pull it down to see what is there. If I recall correctly the plastic compartments lift out and you will see a special kind of hinge that is fastened to the sides of the opening.
Question: If you remove it, what will you put in its place?
Sep 16, 2012, 04:59 PM
Sis2
I looked under there and didn't see anything. I could see light on one side and most of the top which led me to believe the left side was glued. I don't want to remove it, I want to change the hinge and I can't do that unless I can get it open. The one in front of the other sink opens. Don't know why they didn't leave this one open.This message has been edited. Last edited by: Sis2,
Sep 16, 2012, 07:22 PM
Bob Fleming
I'm not understanding what you are seeing, and I have installed a number of these drop-down doors. Is the hinge pin visible from the front on your doors?
Sep 17, 2012, 10:19 AM
Sis2
yes
Sep 17, 2012, 03:35 PM
Bob Fleming
Ok, then you have somewhat standard hinges on the drop-down drawer fronts. There has to be a way to get at the screws holding the hinges in place; after all, the person installing them was no magician! Are there removable plastic (or metal) liners in those drop-down drawers? If so, they will probably be just set in place.
I would also expect that you will need a stubby screwdriver to remove the hinges. Sorry, if this is sounding complicated. Is it possible for you to include a photo or two?
Sep 20, 2012, 09:30 PM
Sis2
No they don't have liners in them and yes I can get to the screws with great difficulty but I still won't be able to get the hinges out without being able to open the stupid thing. I've finally decided it's painted shut in just one corner so I called the guy that's going to paint the bathroom and asked him if he could get it loose. Sounds like he can.
Thanks for your help
Sep 21, 2012, 03:42 PM
Bob Fleming
In my experience screws in hinges placed like that will need either a stubby screwdriver or a small ratcheting offset driver, neither of which you may have.