HGTV Message Boards
Cutting glass tile

This topic can be found at:
http://boards.hgtv.com/eve/forums/a/tpc/f/2074011632/m/8533995367

Oct 04, 2012, 01:36 PM
gwen g
Cutting glass tile
Hello I have a question I have this tile project to do in my kitchen and have everything i need to put the glass and stainless steel tile up.

But I have a concern is there a special tool i need to cut around electical outlets or is it just measuring and cutting pieces with the electric wet saw to make it fit
Oct 04, 2012, 10:23 PM
Chicago Stonepro
The wet saw is the tool.

Regards.


Phil
http://granitesealingservice.com/

Natural Stone Info & Advice
http://forums.findstone.com/
Oct 07, 2012, 07:09 PM
gwen g
Thank you I been hanging on not during the backsplash because I wasnt sure if I had everything I needed.
Oct 07, 2012, 07:39 PM
Chicago Stonepro
You're welcome.

The way it works is, you mark the cuts on the face of the tile, and cut to your marks. The inside corners of the cuts will still be attached. Flip the tile over, and extend the cuts on the backside.

You'll notice you can cut a little past where the cuts intersect, without affecting the appearance of the face.

Sometimes, you can't get the cut all the way through at the corners. No problem. Two ways to approach this, and without knowing your material, I can't say which way it will be best. First, as long as the cut is mostly through, and the cutout isn't too close to the edge of the tile, lightly tap the front side of the cutout with a small hammer, until it comes loose. Second, on the front, cut an X across, connecting diagonal corners, and try tapping with hammer. If needed, flip the piece over and extend the X cuts until the piece is loose, or can be tapped out with a hammer.

Regards.


Phil
http://granitesealingservice.com/

Natural Stone Info & Advice
http://forums.findstone.com/
Apr 25, 2013, 01:27 AM
Becky42
Bump