Message Boards

Hello Friends,

1. Measure the height and width of the opening where you would like the shade to hang, then cut enough fabric for this area, adding 2 inches to the top and 1 inch to the bottom and sides. Cut four 12-inch-long strips of ribbon.

2. To create a rod pocket at the top of the shade, fold the fabric over, forming a 1-and-1/2-inch opening. Pin the pocket into place with sewing pins. Sew along the folded edge of the fabric, removing the pins as you sew along the line. This will help you to keep the pocket straight.

3. Fold the fabric over on the sides and bottom to create a 1-inch hem. Pin the hem into place and sew it closed along the fold line. Remember to remove the sewing pins.

4. Fold over each end of the ribbon pieces 1/2 inch and sew them to the top front and back of the shade along the pocket rod seam approximately 6 inches from each side edge of the shade.

5. Drill holes and attach the curtain rod hardware to the top of your porch overhang or screen enclosure. Thread the curtain rod through the pocket of the shade and hang on the installed hardware. When you want to raise the shade, simply roll or scrunch the fabric up and tie the front and back ribbons together in a bow. Untie when you want the shade down.

Thanks and Regards
Michael Ellgren

Bistro Blinds