I am working on a project where I want to print out on my inkjet pics and then put them onto clear flat marbles. I know the ink will bleed so I was thinking of running through my xyron and put sticky on the ink side...but I still need to seal it. Should I use modge podge or what? I am not adding magnets...they will be used as game pieces.
Check out Krylon "Preserve It", spray sealant?
Make sure to use a good photo paper, and allow to image to dry really well. Light spray coats, both sides of the image.
I use "Workable Fixatif" by Krylon purchased at Michael's. Most of my printing is then run through my Xyron laminate cartridge and there is no smudging of the ink.
Peruvian Paso-The Glide Ride With Attitude
What about using the Xyron cartridge that applies adhesive to one side and laminate to the other?
"Welcome to reality would you like some popcorn?"
|Powered by Social Strata|